שאלות נפוצות בנושא מנועי סרוו               

1.  How to send the motor parameter  as one  batch to the driver ? 
 
2.  How to calibrate the motor and make fine tuning   ?

3.  Is it possible to use EDB with 1 phase  ? 

4.  The communication become very slow when Servo is ON, what should we do   
      in order to communicate faster?

5.   In the EDB Series, the following parameters used for positioning. what parameters    
      are  equal to these parameters in the EDC Series. If there aren't equal parameters,   
      how do I perform the positioning in the EDC drive?

6.   What is the pinout for the RS485 in the EDB series?

7. How can  I change the Baud Rate of the communication at both series of drives,  and  

    what Baud Rate is available?

8.    EDB

       Pn218 Suitable motor type parameter 0~3

       What is the parameter definition?

       Pn218 = 0 ?

       Pn218 = 1 ?

       Pn218 = 2 ?

       Pn218 = 3 ?

9.   Absolute encoder

1)      With Absolute encoder, after one turn, is the position reset to zero or continue to count up.

2)       With Absolute encoder, how do I reset position (reference point)?

3)       With Absolute encoder, in parameter position control, does it work the same   like it is working with incremental encoder?

10.     I Would like to connect the PG Frequency dividing output (PA0, /PA0, PB0, /PB0,
           PC0, /PC0) to a regular 24 VDC High speed counter plc input,  do you have a  
           converter, or you know how make a converter of this kind?